Do you often get welcomed by the mywifiext.local not working error message every time you try to log in to your Netgear WiFi range extender using your Apple device? Well, you might be facing this issue because of various issues: loose Ethernet connection, too much distance between your wireless devices, outdated firmware, incorrect web address used, wrong login credentials used, technical glitches, WiFi interference, faulty hardware, outdated web browser, and much more.
But, regardless of the reason why you’re unable to access the mywifiext.local page, the tips are given below will surely help you troubleshoot the issue. So, scroll down, and read on.
Fixed: Mywifiext.local Not Working Issue
- Bring Your WiFi Devices Closer
Start by reducing the distance between your Netgear WiFi range extender and home router. Bring your extender into the same room as your wireless router. Once you feel that the issue mywifiext.local not working has been resolved thoroughly, you are free to change the location of your Netgear extender.
- Check the Power Supply
Make sure that your Netgear WiFi range extender is plugged into a working wall socket and getting an adequate power supply. If the wall socket to which your device is connected is damaged from anywhere, it is recommended that you plug your Netgear wireless range extender into another wall outlet.
- Verify the Ethernet Connection
As mentioned earlier, a weak Ethernet connection between your extender and router can also be one of the major reasons why you’re stuck with the mywifiext.local not working issue. Thus, make sure that the Ethernet cable connecting your WiFi devices is not worn out or damaged from anywhere. In case it is, replace it with a new one.
- Perform Netgear Firmware Update
Updating the firmware of your Netgear WiFi range extender to the latest version can also help you get rid of the issue you’re currently facing. Therefore, waste no more time, refer to the step-by-step guidelines mentioned in this user manual, and learn how to perform Netgear extender firmware update.
- Use the Default IP Address
Have you not entered the correct web address in the address bar of your web browser to access the Netgear Genie setup wizard? Probably not. But, worry not. You can still rectify your mistake. Enter the correct web address and cross-check it. If doing none of these things work for you, use the the default IP address to log in to your Netgear range extender.
- Switch to Another Web Browser
Using an outdated web browser to log in to your Netgear WiFi range extender can be a wrong step to take. Therefore, ensure that your web browser is up-to-date. Also, clear its cache, cookies, and browsing history. If you still find no luck, then consider switching to another internet browser to access mywifiext.local.
- Reset Your Netgear Extender
If you are reading this tip right now, then we are sorry to say – you are left with no other option than to reset your Netgear range extender.
Follow the instructions mentioned below and learn how to restore your Netgear WiFi range extender to the default factory settings:
- Look for the Reset button located on your wireless extender.
- Once found, take an oil pin, toothpick, or a paper clip.
- Now, carefully press the Reset button, and wait for some time.
Once you are done resetting your Netgear WiFi range extender to the default factory mode, reconfigure your extender, and connect as many devices to its Netgear_ext as you want.
Bottom Line
Hopefully, the troubleshooting tips mentioned in this post will be able to help you resolve the mywifiext.local not working issue. If what we are hoping for comes true, don’t hesitate to leave a word of appreciation in the comment section below.
