Cigarette burns are not only unsightly, but they can also cause serious damage to carpet fibres if left untreated. If you smoke cigarettes, you know how damaging these little burns can be. But what do you do about them? Here’s a quick guide to repairing cigarette burns on the carpet.
Table of Contents
Repairing the cigarette burn marks
If you have a cigarette burn mark on your carpet, don’t despair! You can repair it with a little time and effort.
Step 1
First, remove any loose particles of tobacco ash that may have fallen onto the carpet. Then blot the area dry using a clean towel.
Step 2
Apply a small amount of carpet cleaner directly to the affected area. Make sure to get under the edges of the burn. Let the cleaner sit for a few minutes before vacuuming it out.
Step 3
Vacuum the entire room, including the spot where the burn occurred. Be careful while vacuuming the burnt area. You don’t want to pull up any loose particles of tobacco.
Repairing cigarette burn
- If the cigarette burn is small, you can try to repair it with a carpet repair kit. These kits are specifically designed for repairing burns on the carpet and usually come with all the tools and materials you need. However, nothing compares to the carpet repair Canberra professionals who are equipped with the latest techniques for carpet burn repair.
- If the cigarette burn is larger, you may need to replace the affected area of the carpet. You can either patch in a new piece of carpet or opt for carpet stretching for the entire section of the carpet.
- If the cigarette burn has gone through to the backing of the carpet, then you will need to replace the entire section of the carpet. This is because the backing of the carpet is what provides most of its strength and stability.
Repair cigarette burn – Method -1
1. Cut a generous circle around the burn with a utility knife.
2. Use tweezers to remove any singed fibres from the burn area.
3. To prevent further damage, try to cut just above the level of the burn.
4. Apply a sealer to the surface of the carpet to prevent future staining. A good quality sealer will help restore the colour and texture of the carpet.
5. Sand down the surface of the burn with sandpaper, until the carpet appears smooth again.
6. After sanding down the burn, wash away any excess residue with a damp cloth. Wipe the burn area with a disinfectant spray to kill bacteria and germs.
Repair cigarette burn – Method -2
1. First, Trim the Frayed Carpet Fibres
Remove any loose threads or fibres from the burn. Use sharp scissors to trim the frayed carpet fibres around the cigarette burn. Be careful not to cut too deeply into the carpet backing.
2. Second, apply heat to the carpet burn
Use a clothes iron on the steam setting to apply heat to the carpet burn. Hold the iron about 2 inches above the burn and move it back and forth for about 30 seconds. This will help to seal the burned fibres so they won’t fray further.
3. Finally, use a repair kit or patch to cover the cigarette burn
If you have a repair kit or patch that matches your carpet, use it to cover the cigarette burn. If not, you can always use a piece of similar-coloured duct tape. Just be sure to smooth it down so there are no wrinkles or bubbles. Apply a small amount of adhesive to the area and press a piece of fabric into it. Allow the adhesive to dry completely before walking on the area.
Conclusion
If you have ever smoked cigarettes then you know how damaging they can be to carpets. Once the smoke is trapped in the fibres of the carpet it is nearly impossible to get out without professional help. Carpet Repair Wollongong have the expertise in carpet repair and carpet restretching.
