Wire rope lubricators are an essential part of any wire rope installation. They help keep the wire ropes running smoothly and prevent them from wearing down prematurely. However, it is essential to choose the right lubricator for your needs. When it comes time to choose a suitable wire rope lubricator for your business, give a thought to Viper WRL. However, it can prove quite costly if you commit a mistake while using it. To ensure the best selection, look at this now.
Below, we will discuss some mistakes people make when using a wire rope lubricator.
Common Mistakes to Keep at Bay While Using WRL
Table of Contents
Mistake #1 – Not cleaning the surface first
It may seem like an obvious step, but many people don’t bother with it. Before applying any oil or grease to a surface, be sure that there is no dirt or debris present which could cause problems later on down the line. This will ensure that all surfaces are clean and free from contaminants before application begins.
Mistake #2 – Using too much oil
A little bit goes a long way when it comes to lubricating cables and wires properly! Too much can actually do more harm than good by causing excess buildup over time, leading to corrosion issues further down the road if not addressed immediately after they occur. Be sure not to use too much as you apply your wire rope lube; just enough is needed for proper coverage without leaving behind excess residue, which can attract contaminants and other harmful particles in its place over time as things start moving again.
Mistake #3 – Using too much lube
This is one of the most common problems with wire rope lubricators because it leads to excess waste and contamination in your system. The best way to prevent this mistake is by following the manufacturer’s instructions on how much lube should be used per application or hour of use. You also need to monitor the amount of lube being dispensed from each nozzle over time to know if any adjustments need to be made during the operation. It’s essential not only for efficiency but safety as well! Never exceed 10% oil concentration in water systems or 15% in glycol systems (which is often considered an industry standard). You don’t want oil concentrations above these levels because they will cause corrosion issues within your system, leading to downtime and expensive repairs down the line!
Mistake #4 – Using old oil in your machine
It happens because you didn’t know when it was last changed out or refilled with fresh oil. Old oil doesn’t work as well as new, clean, fresh-squeezed oil, so make sure you change it regularly! You should also check your manufacturer recommendations on how often this should be done based on usage and environmental conditions of the area where the machine is being used (i.e., dry vs. humid). The best practice would be monthly, but some machines may need changing every 3 months depending on their usage levels and environmental factors like humidity, etc.
The Bottom Line
Wire rope lubricators are a great way to keep your equipment running smoothly and efficiently. But if you don’t use them correctly, they can actually do more harm than good.
